@Filip009 I would definitely try running it with only the 1 active WAN port selected as a WAN. That should prevent any failover or loadbalance config issues from causing trouble.

@bigal_12ms The controller will let you set up ACL at Gateway/Switch/AP. You will be most successful implementing your ACLs at the Switch level. Your Pfsense will ignore anything you try to do a as a...

@bigal_12ms Nope, you double configure everything. So leave Pfsense exactly how it is, and we're going to use the controller to make the rest of the Omada kit dovetail seamless with the existing...

@bigal_12ms If you don't change the Pfsense...then you need to redefine your Omada LAN to match the Pfsense... ie below would need to change to 192.168.1.1/24

@bigal_12ms This is where you would change it, but you will cause outages for 5-10min as everything reconverges/re-IPs. Choose wisely :)

@bigal_12ms Ok, it looks like you are going forwards with your management subnet being 192.168.1.0/24. This is ok, I do run some sites on IP's other than the default subnet, but it's easier when...