Hello there, I have an Archer MR400 with hardware version v4.20 (at least this is what is written on its label on the bottom), but the admin page says: Firmware Version:‪1.0.0 0.9.1 v0001.0 Build 2106

My main router is an Archer AX21 Hardware Version 2.6 Firmware version 2.1.5 My older TL-WR940N router will not connect to the internet if used as an access point for the main AX21. When used as a ran

Hello Everyone, I am trying to add pfsense firewall to my home network but seem to be running into issues getting it seen by my pfsense firewall which is a dual nic server. I had it working briefly th

Home setup. not an expert by any means. cable-->Internet router ---> SG105 switch ----> TL_WR841 AP I setup port based VLAN (not 802..1Q VLAN) in the switch and I am able to connect with laptop with i

I have internet via an Antena and I have 3 zones where I want to add internet routers. Each zone has 30meters of cable between the routers. I have been trying all day to get them to work.. they work f

The Router's Web UI / Mobile App shows status as 'No Internet' even though the connected devices are successfully connected to the Internet. Happens in both Router/Access Point Mode. Also, If initiall