WR700N loses connection about once/day
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WR700N loses connection about once/day
Region : Canada
Model : TL-WR700N
Hardware Version : V1
Firmware Version : latest
ISP : Cogeco
I have a WR700N set up in bridge mode so as to provide a wifi signal in far end of our home. I used Bridge so we can tell which router we are connecting to. So we have two SSIDs (MySSID1 and MySSID2) Both with secure log-in.
This works fine for about a day, and then disconnects. I then have to mess with the WR700N by plugging it in and out, maybe logging into it and changing something. Then it will work again - for a day :(
I updated the firmware with no change.
Main router is a Dlink 615 with IP of 192.168.0.1. connected to cable modem. TP-LINK is set at default of 192.168.0.254 and gets a wireless signal from dlink.
In an attempt to improve situation, I now have both units set to channel 11 and with fixed 20Mhz channel width. b/g/n on TP and g/n on dlink.
Any suggestions?
Model : TL-WR700N
Hardware Version : V1
Firmware Version : latest
ISP : Cogeco
I have a WR700N set up in bridge mode so as to provide a wifi signal in far end of our home. I used Bridge so we can tell which router we are connecting to. So we have two SSIDs (MySSID1 and MySSID2) Both with secure log-in.
This works fine for about a day, and then disconnects. I then have to mess with the WR700N by plugging it in and out, maybe logging into it and changing something. Then it will work again - for a day :(
I updated the firmware with no change.
Main router is a Dlink 615 with IP of 192.168.0.1. connected to cable modem. TP-LINK is set at default of 192.168.0.254 and gets a wireless signal from dlink.
In an attempt to improve situation, I now have both units set to channel 11 and with fixed 20Mhz channel width. b/g/n on TP and g/n on dlink.
Any suggestions?