tp-w9970 - medem only mode?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

tp-w9970 - medem only mode?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
tp-w9970 - medem only mode?
tp-w9970 - medem only mode?
2019-12-01 09:22:34 - last edited 2019-12-03 08:06:11
Model: TD-W9970  
Hardware Version: V2
Firmware Version: 170919

Hi there, as per title I have a w9970 however I am plugging this into my existing WiFi network made of number of pre-interconnected WiFi routers, so I would need this device to be "just" an ADSL modem.

My ideal scenario is where the only connected device on the w9970 LAN (an Asus dedicated router) gets a public IP address on its WAN interface.

Is there any way to set up this device to be modem only?

 

Thanks!

  0      
  0      
#1
Options
1 Accepted Solution
Re:tp-w9970 - medem only mode?-Solution
2019-12-03 08:06:08 - last edited 2019-12-03 08:06:11

@rs232 

 

Thanks for your requesting. For your information, the TD-W9970 is the bridge mode/modem only by default. 

 

You can hard reset it by holding the reset hole for 10s with it powered on to get the modem only.

 

May it help. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:tp-w9970 - medem only mode?-Solution
2019-12-03 08:06:08 - last edited 2019-12-03 08:06:11

@rs232 

 

Thanks for your requesting. For your information, the TD-W9970 is the bridge mode/modem only by default. 

 

You can hard reset it by holding the reset hole for 10s with it powered on to get the modem only.

 

May it help. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options