TD-W9970 problem with bandwidth control

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TD-W9970 problem with bandwidth control

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD-W9970 problem with bandwidth control
TD-W9970 problem with bandwidth control
2019-12-12 12:30:52 - last edited 2020-08-07 02:03:03
Model: TD-W9970  
Hardware Version: V2
Firmware Version: 0.9.1 0.2 v0076.0 Build 170919 Rel.61201n

i have problem with badwidth control feature , my actual speed on the line is 30 MB when i enable bandwidth control even before i make any Control Rules the speed is reduced to the half and become 15MB  but still showing up 30MB in the status of Dsl , but the actual is 15 only . if i make any Rule to control the speed i can't take my full speed , only 15 MB i can make for all devices even if i write the full speed in the rule for any device what will reach is 15Mb only , if i want to back the full speed again i must disable bandwidth control feature .

Any help on this issue?

  0      
  0      
#1
Options
1 Reply
Re:TD-W9970 problem with bandwidth control
2019-12-20 08:55:11 - last edited 2020-08-07 02:03:03

@Abdelrhman 

 

With bandwidth control enabled, the data packet will be transferred by CPU, which limits the actual speed you can get even though there is no rule added. 

 

I'm afraid that there is no option to avoid this; it is designed so. 

 

Meanwhile, if the bandwidth is adequate for the daily network activities, it is not suggested to enable bandwidth control. 

 

Good day. 

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1141

Replies: 1

Related Articles