Connecting to far Deco, instead of near one
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Connecting to far Deco, instead of near one
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello guys.
We have 9 Decos, and they change their connection (deco to deco) everyday. But all of them stay in one place.
Sometimes I need to reboot 1 deco, so this one will connect to the nearest one. Would be great, if we could manually or at least give them priority to chose, which Deco to connect.
I don't want to reboot it everytime, just because it connected to the far one (speed dropping really hard).
P.S talking about Deco to Deco connection.
Each picture taken a few minutes after.
Also please let them have their real names, instead of "custom_1"
Take care, stay home and don't hug strangers!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Thank you very much for your feedback, we will keep recording the same kind of request. Then we can forward it to our product engineer and they can work on it.
If there are any updates, we will upload it to our official website. It is very suggested to keep an eye on the official website and wait for the updates.
Good day.
- Copy Link
- Report Inappropriate Content
Yes, +1 on that too! Happens on the M9 Plus aswell! Please have a look at all the other problems. They have been ignored for months now!
- Copy Link
- Report Inappropriate Content
Thank you very much for your feedback, we will handle the case on the community as soon as possible.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
same with my 5 P7s!
- Copy Link
- Report Inappropriate Content
@Lexivienna @Shawon_Maity @MarekT
Hello, the signal source is not selectable right now, the Deco connects to the front-end device automatically based on the signal strength. If the 3rd or 4th unit is always connected to the furthest Deco and the performance is not good, try to move them further away from each other. And you can reboot the 3rd Deco and verify whether it will connect to the 2nd one.
- Copy Link
- Report Inappropriate Content
@TP-Link_Deco
2020 almost over, and still nothing to hear about those features :(
- Copy Link
- Report Inappropriate Content
@Boriy same issue. Is there any resolution? My middle deco has 5 bars but nothing connects to it, always connects to the farthest deco even after reboot
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, a new firmware for Deco E4 has been released several months ago and there is a new feature called Network optimization.
Have you tried to update to the latest firmware and optimize the network to check whether the signal source of the Deco would change or not.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 4390
Replies: 13
Voters 1
