I followed wrong instructions and changed my IP address and now can’t get wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I followed wrong instructions and changed my IP address and now can’t get wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I followed wrong instructions and changed my IP address and now can’t get wifi
I followed wrong instructions and changed my IP address and now can’t get wifi
2020-06-11 00:33:26 - last edited 2020-06-11 02:56:01
Model: Archer VR600v  
Hardware Version:
Firmware Version:

I was trying to set up my new modem and the wifi wouldn't work, i went online and looked up how to connect and found instructions. i followed them, and now can't connect at all. 

I went and had a look at the title of the instructions i followed and it says: 

"How to setup a TP-Link DSL modem router as an Access Point?"

in which i wasn't wanting to do. I have now changed the IP address and it now won't let me connect. what do i do?! 

i am not good at technology!!

 

  0      
  0      
#1
Options
1 Reply
Re:I followed wrong instructions and changed my IP address and now can’t get wifi
2020-06-11 02:55:51 - last edited 2020-06-11 02:56:01

@ashleeanderson 

 

Hello, kindly refer to the below instructions to log into the web management page of the modem:

How to log into the web-based interface of the AC VDSL/ADSL Modem Router

 

If you still fail to login, please reset the modem by pressing and holding the reset button on the back panel for more than 8s until all the LEDs are off then on.

 

Here is the instruction may guide you to set up the internet on the modem:

ADSL Modem Router All-in-one Troubleshooting Guide

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 489

Replies: 1