I am trying to make the modem in bridging mode with wds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I am trying to make the modem in bridging mode with wds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

sabu

2020-11-18 01:45:23 - last edited 2020-11-18 01:53:36

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-11-18

I am trying to make the modem in bridging mode with wds

2020-11-18 01:45:23 - last edited 2020-11-18 01:53:36

Model: TD-W8961N

Hardware Version: V2

Firmware Version:

I am trying to connect the modem to the main router in bridging mode with WDS

I deactivated DHCP and changed the ip address also

but it is still unable to connect

1 Reply

Kevin_Z

2020-11-20 11:55:34

Posts: 21782

Helpful: 5158

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:I am trying to make the modem in bridging mode with wds

2020-11-20 11:55:34

@sabu

Hello, you may refer to the below instructions to configure it to bridge the main router's wireless:

https://www.tp-link.com/support/faq/327/

While please be aware that it will use the 4-address to connect other wireless networks when configuring the WDS bridging on it and it might be incompatible with your existing router.

We hope it works for you.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

I am trying to make the modem in bridging mode with wds

I am trying to make the modem in bridging mode with wds

Information

Voters 0

Tags