IPSEC VPN Phase 2 fails

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IPSEC VPN Phase 2 fails

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ferret133

2020-12-03 13:33:33

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-03

IPSEC VPN Phase 2 fails

2020-12-03 13:33:33

Model: Archer VR2100

Hardware Version: V1

Firmware Version: 1.1.0 0.9.1

Hi,

We have install brand new VR2100 this afternoon, everything is working as it should, then configured site-20-site ipsec vpn....for about an hour or so it worked perfectly....

Since it stop working we rebooted and reset the modem, reinstalled site-2-site and still no luck..

The modem establishes phase 1 with no issue, the routers at both ends report an up status on the link.

Now the issue is phase 2 fails to establish a connection...

Any assistance woiuld be very much appreciated.

Cheers

1 Reply

Kevin_Z

2021-01-07 07:22:11

Posts: 21750

Helpful: 5135

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:IPSEC VPN Phase 2 fails

2021-01-07 07:22:11

@ferret133

Please refer to the below instructions to reconfigure the IPSec VPN on both sides:

https://www.tp-link.com/support/faq/1752/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

IPSEC VPN Phase 2 fails

IPSEC VPN Phase 2 fails

Information

Voters 0

Tags