problem in my router
i have ip static , and i configured it on my router , but when service down and up again , or electricty cut and come again the internet is not up until i remove ip ststic from router and re-assign again
and router didn't accept the subnetmask from isp , 255.255.255.252
what shoud i do to correct configure
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Have you tried to update the firmware to be the latest one: ArcherVR400(EU)_V2_201104?
Did you use the Archer VR400 as a DSL modem router or wireless router?
---if it is the wireless router, have you tried to set up the same static IP settings on the computer to see if the PC had the same issue?
Would there be any error message when the router did not accept the subnet mask 255.255.255.252?
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
@TP-Link ok i wil do this
thanks alot
- Copy Link
- Report Inappropriate Content
@Ta7 hi
now i upgrade the firmware you sent to me but the same problem .
i use it as as a VDSL modem router
what i do now ?
can i upgrade firmware to v3 ?
- Copy Link
- Report Inappropriate Content
Hi, we could not use the firmware of V3 on the V2;
May I know who is your internet service provider and Is the static IP connection required by the internet service provider?
Have you tried the Dynamic IP on the Archer VR400?
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 432
Replies: 4
Voters 0
No one has voted for it yet.