Hi,

If anyone can give me some advice on this because I am stumped!

When running the main deco and only the main deco the system works well, with decent speeds and signal through my 102 square meter flat. Although once I get the satellite deco up and running there are major issues. They are as follows:

1. iOS devices disconnect frequently and battle to reconnect.

2. Internet speeds drop by about 50% when connected to what I assume is the second deco. Being connected to satellite getting around 10mbs (right next to it) and when only using the single main deco in the same spot getting 30mbs plus.

I have tried the following:

1. Moving the satellite a few meters away from the main deco, causes the same issues as listed above.

2. I have tried swapping the main deco and satellite deco but get the same results. Seems to be a software related issue to me.

3. I have reset both decos.

4. I have disabled beam forming and fast roaming.

I have took to just turning off the satellite deco as the results are better which shouldn't be the case, any advice would be greatly appreciated. I must mention before upgrading to 1.5.1 I had none of these issues (previously had them for two days before upgrading) so it seems to me this is definitely a software issue.