M4R & E4R High Channel Interference.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My deco app says that there is a lot of wireless interference however I have no way to change the channel. How do I correct this?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, firmware 1.4.3 does not support network optimization which will be added on the firmware 1.5.x.
It is suggested that you could install the beta firmware on this link：
[Solution] Wi-Fi speed drops down after updating Deco M4 to the latest 1.5.0 firmware
And did you have any issues when receiving the High Wi-Fi Interference warning, like slow speed, unstable network?
Thank you very much.
- Copy Link
- Report Inappropriate Content
@TP-Link Thanks, I didn't have any issues other than a wifi scan was showing interference, I managed to get the firmware installed using Firefox as Chrome wasn't completing the upgrade. I can now run network optimization and UPNP is working (it would not stay enabled under the 1.4.3 firmware).
However I still receive the same warning in the App.
- Copy Link
- Report Inappropriate Content
Hi, if there is no specific performance issue, it is suggested to wait a while for the new.
The network optimization will be optimized along with the firmware.
For more details, it is suggested to have a look at this link:
[Solution] Network aways congested according to the Network Optimization on the Deco app
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 708
Replies: 3
Voters 0
No one has voted for it yet.