Cannot Access the Internet when connecting an Archer AX6000/AX11000 to Starlink Gen 2

Cannot Access the Internet when connecting an Archer AX6000/AX11000 to Starlink Gen 2

63 Reply
Re:Cannot Access the Internet when connecting an Archer AX6000/AX11000 to Starlink Gen 2?
2023-09-30 06:35:28

  @dwdaubert we had this same router installed ,first leave the starlink in unbypassed mode,next connect a good,verified cat 6 cable to the 2.5 ghz wan port (blue) set up your router via tether ap,set it to dynamic dhcp , set up your ssid that you have binded any smart lighting,t stats or alexa devices to,we used same ssid on both bands,they say this may cause double nat issues ,we run 53 devices on this router and and 46 being wireless,hit all the save configs and it worked with both starlink and ax6000 in router mode,weather or not the ax6000 recognised the double nat or not we seen no issues,so i upgraded to the new tp link axe300 ,4 bands 2.4,5.1,5.2,6.0 mhz channels on the same ssid with smart connect enabled ,i will say this router is so far the fastest i have seen,when testing a i phone wirelessly between the axe300 and starlink download speeds it was so much faster , but if you are not using the number of devices at 50 to 60 max you should have no issues with the ax6000 ,we tested it for over a year while adding 10,20 ,30,40 then 50 plus devices,hope this works ! kevbo

  1  
  1  
#64
Options
Re:Cannot Access the Internet when connecting an Archer AX6000/AX11000 to Starlink Gen 2
2024-03-08 22:51:23

  @Kevin_Z 

What is the lastest about this issue? Can we now update the router to the last firmware update? I have the AX11000 v1.

  0  
  0  
#65
Options
Re:Cannot Access the Internet when connecting an Archer AX6000/AX11000 to Starlink Gen 2
2024-07-14 17:43:58

IS THERE ANY UPDATE TO FIRMWARE ON TP LINK AX6000 V1 

  0  
  0  
#66
Options
Related Articles