Luces parpadean y no puedo acceder la Interfaz

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Luces parpadean y no puedo acceder la Interfaz

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Luces parpadean y no puedo acceder la Interfaz
Luces parpadean y no puedo acceder la Interfaz
2023-04-16 16:38:08 - last edited 2023-04-21 03:47:48
Model: TL-WR841HP  
Hardware Version: V5
Firmware Version: 210414

Traté solucionar el problema apretando el botón reset por 10 segundos, también intenté reinstalando el firmware. Pero siempre termina pasando lo mismo : todas las luces parpadean al mismo tiempo no importa cuánto tiempo lo deje asi.

  1      
  1      
#1
Options
1 Accepted Solution
Re:Luces parpadean y no puedo acceder la Interfaz -Solution
2023-04-21 03:47:44 - last edited 2023-04-21 03:47:48

Hello @Arreca09 

 

As per your description, it seems the router is not functioning properly, please check the below suggestions and proceed: 
1. Be sure you are using the original power adapter, and ensure that the power button on the back has turned on.
2. Try another power adapter with the same power specification, which is 12 V ⎓ 1 A.
3. Try to reset it by holding the reset button for 10s or longer to see if it will change anything.
4. Is there any power outage/bad weather before it behaves like that?

 

If nothing helps, it's suggested to contact the local tech support to be advised further:
https://www.tp-link.com/support/contact-technical-support/

Recommended Solution
  3  
  3  
#2
Options
2 Reply
Re:Luces parpadean y no puedo acceder la Interfaz -Solution
2023-04-21 03:47:44 - last edited 2023-04-21 03:47:48

Hello @Arreca09 

 

As per your description, it seems the router is not functioning properly, please check the below suggestions and proceed: 
1. Be sure you are using the original power adapter, and ensure that the power button on the back has turned on.
2. Try another power adapter with the same power specification, which is 12 V ⎓ 1 A.
3. Try to reset it by holding the reset button for 10s or longer to see if it will change anything.
4. Is there any power outage/bad weather before it behaves like that?

 

If nothing helps, it's suggested to contact the local tech support to be advised further:
https://www.tp-link.com/support/contact-technical-support/

Recommended Solution
  3  
  3  
#2
Options
Re:Luces parpadean y no puedo acceder la Interfaz
2023-04-24 13:25:31
Traté con 2 diferentes fuentes de alimentación de salida: 12v==1000mA , y el problema persiste.
  0  
  0  
#3
Options