down bandwidth speed ethernet backhaul satellite router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
guys i have question about down bandwidth speed.
i use ax 73 as main router than connect to ax 10 as satellite router with ethernet backhaul use cat6 cable, if i near main router the speed is normal like 30mbps and than if near of stellite router the speed down like 2 mbps its same before i use ethernet backhaul.
note: icon in easymesh is ethernet and link speed 1000mbps wire
please guys help me this is so annoying like the easymesh is useless. if you have solution pls reply it.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Are you sure your client device actually switches itself over to the Wi-Fi of the AX10 router?
If unsure, can you please use some software or app to determine whether your client device is actually connected to the AX10 when you get only 2 Mbps?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Ok.
Can you please try the following?
Make sure the Cat6 Ethernet cable coming from the AX73 is plugged into the blue WAN port of the AX10.
Now reset the AX10 to factory settings by pressing and holding its "Reset" button for about 8 seconds.
Wait a while until the AX10 has booted up again.
The AX10 should now emit two Wi-Fi SSIDs. Something like TP-Link_xxxx and TP-Link_xxxx_5G.
Connect your client device to the network TP-Link_xxxx_5G using the Wireless Password/PIN that is printed on the label on the bottom of the AX10.
Now check if the speed is still only 2 Mbps.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
if ax10 not in mesh connection 20mbps than ax 10 back to mesh connection the bandwidth down again
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
denss wrote
if ax10 not in mesh connection 20mbps than ax 10 back to mesh connection the bandwidth down again
Hi, do you mean satellite router WiFi speed is 2Mbps when using EasyMesh Ethernet backhaul, while if you use AX10 as a regular AP mode without mesh, its WiFi speed can be 20Mbps?
When using EasyMesh ethernet backhaul, please connect a computer to the AX10 satellite via Ethernet cable to test if the issue is with both wired and wireless connection, or only WiFi speed slow.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 841
Replies: 8
Voters 1