Deco P9 - Powerline backhaul connection preference

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco P9 - Powerline backhaul connection preference

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco P9 - Powerline backhaul connection preference
Deco P9 - Powerline backhaul connection preference
2024-04-11 10:02:53
Model: Deco P9  
Hardware Version: V1
Firmware Version:

Hi, I installed 3x Deco P9's in a 3 storey house in Access Point mode yesterday.

 

The main unit connected to the router is on the ground floor, with 2nd unit on the 1st floor (medium signal) and 3rd unit on the 2nd floor (weak signal).  The network map in the app shows that both the units on the 1st and 2nd floor are connected by powerline to the main unit.

 

With regards the 2nd floor unit showing a weak signal, should this not be connecting by powerline to the 1st floor unit to obtain a stronger signal?

 

Thanks

  0      
  0      
#1
Options
1 Reply
Re:Deco P9 - Powerline backhaul connection preference
2024-04-12 11:29:51

  @MingFoo 

Hi, welcome to the community.

Have you checked the internet speed from the two satellite Deco P9s?

I remember the signal strength on the Deco APP only measures the signal level of the WiFi Mesh Backhaul.

When Deco P9 works in Powerline Backhaul, Its signal source should be from the main Deco P9.

Thank you very much and best regards.

 

  0  
  0  
#2
Options