Hi, 

After some advice.... Having trouble with my network.

The main bit hub (fttp) is in one house. I have a cat 6 cable going through to next door to a switch ,this runs data point for the house. Approximately 25m away.

I setup a new network before for the house but keeps dropping a lot. 

I'm wanting to reset up the original network  can I just plug in a few m5's to the data points and use them as AP's?

My question is... The main m5 at the router do I connect the cat 6 that goes to the switch into the out off the M5 at the router?  ( Does that make sense)

Thanks jamie