Put my Archer AXE5400 in Access Point but ?
Hi all, I was reading an article about putting your AXE5400 into the access point mode to use with the Quest 3 so I followed the instructions. Now I find I can't reach the router via my browser, so I have no way of returning it to its original setting/ taking it out of access mode.
Is there any way of reversing this if I want to go back to using the router as it was before I changed it?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Yes, there is. Fastest one is to reset the AXE5400 to its factory defaults by pressing the reset button for about 10 seconds.
The other one is to find its IP address on your main router and use http://router_IP_address to login the device and chaneg its operation mode.
- Copy Link
- Report Inappropriate Content
Yes, there is. Fastest one is to reset the AXE5400 to its factory defaults by pressing the reset button for about 10 seconds.
The other one is to find its IP address on your main router and use http://router_IP_address to login the device and chaneg its operation mode.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 610
Replies: 2
Voters 0
No one has voted for it yet.