Hai All,

 

I facing issue with Deco X10 where didn't get full speed on the Wi-Fi 6. My subscription is 200Mbps up and down. The reason why I use Deco X10 as AP mode is because I'm using pfsense as my main router while Deco X10 as AP only.

 

1. Doing testing using direct switch - able to get 200Mbps up and down.

2. Doing testing using LAN port at Deco X10 - able to get 200Mbps (Nearly 200Mbps) up and down.

3. Doing testing using Wi-Fi 6 - Able to get 137Mbps down and 146Mbps for up.

4. Set Deco X10 as router mode + PPPoE - Able to get 200Mbps up and down.

 

I've also try do as below :

 

1. Downgrade to the lowest version of Firmware - Cannot get 200Mbps up and down for Wifi.

2. Try to upgrade firmware follow the path - Cannot get 200Mbps up and down for Wifi.

3. Disable flow control - Cannot get 200Mbps up and down for Wifi.

4. Disable OFDMA + MU-MIMO + BEAMFORMING - Cannot get 200Mbps up and down for Wifi.

 

Apprecite if anyone could advise what should I do next. Please be informed that the Access Point mode doesn't have QoS, so it disabled by default.

 

Speedtest using LAN direct switch.

 

Speedtest using Wi-Fi6 from Deco X10

 

Direct LAN port at Deco X10

 

Using other router as AP (Wifi 5 only).

 

Wi-Fi 6 link speed is 1081Mbps for RX 961 for TX.