Virtual Servers error code 4620 on TP-Link Archer VR1210v
While I can add virtual servers for other ports (see 443 in the screenshot) I have a problem trying to add port forwarding on port 80 on my VR1210v:
The port is NOT used since I moved local and remote management on other ports (local was on 80/443 before):
Is there a way to fix this error?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I can add that local management on port 8080 works and nothing respond on port 80 so it should be free.
- Copy Link
- Report Inappropriate Content
A similar behavior could be observed if the router has its UPnP feature enabled. Disable UPnP and reboot the router, then try to port-forward TCP 80 again.
- Copy Link
- Report Inappropriate Content
@terziyski thank you for your answer but sadly UPnP is already disabled.
- Copy Link
- Report Inappropriate Content
VR1210v is an ISP provided device and probably a newer FW release could fix this. Unfortunatelly you can obtain a newer FW release only from your ISP (it they have one) or at least ask them for assistance on this issue.
- Copy Link
- Report Inappropriate Content
@terziyski mine is ISP provided but I managed to update to the latest version already (cracked admin pass from config backup... it is my work) but even with some knowledge still can't find the problem and have no time to dig into the firmware now.
any other suggestion?
- Copy Link
- Report Inappropriate Content
Hi, I think you could try to back up the current network configuration, and then factory reset the modem once.
After that, before configuring the internet, you could change the default local management port to something other than port 80. Then open port 80 again to see whether the same error pops up again.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 328
Replies: 6
Voters 0
No one has voted for it yet.