Home Network Community > Feature Request (Deco) > BE95 MTU setting under access point mode
< Feature Request (Deco)
 
3
Votes

BE95 MTU setting under access point mode

 
3
Votes

BE95 MTU setting under access point mode

BE95 MTU setting under access point mode
BE95 MTU setting under access point mode
2024-10-29 15:57:19
Tags: #Access Point Mode #MTU
Model: Deco BE95  
Hardware Version:
Firmware Version:

Feature request - please enable the option to set mtu sizes for each lan port when in access point mode (not router mode).  It should be necessary to allow jumbo frame sizes for 2.5g, and especially for the 10g sfp+ port on the BE95 unit.

#1
Options
2 Reply
Re:BE95 MTU setting under access point mode
2024-10-30 03:03:14

  @kamphor 

Hi, Thank you very much for the feedback.

I will note down the feature request first and review if there will be more similar feedback.

Even in router mode, it only allows to edit the MTU on the WAN port. Configuring Per-Port MTU might still require careful consideration.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.
#2
Options
RE:BE95 MTU setting under access point mode
2 weeks ago
I am using BE95 as access point for BPI-R4 router and it support jumbo frame MTU 9198 Please give an option to setup same MTU for all ports of BE95 to use this for whole home network
#3
Options

Information

Helpful: 3

Views: 76

Replies: 2

Voters 4

voter's avatar
voter's avatar
voter's avatar
voter's avatar

Tags

Access Point Mode
MTU
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.