Hub et interphone d230s1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bonjour
je viens d'acheter un d230s1 v1.2
J'ai installé le matériel
Je n'arrive pas à faire cette fonction que je souhaiterai
lorsqu'il n'y a pas d'action du bouton de la sonnette la caméra est en mode confidentiel
lorsqu'il y a action du bouton de la sonnette celle ci sonne et enregistre et me fait une notification
pouvez vous me dire ci c'est possible comment le réaliser
cdt
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Tapo D230 doesn't have a direct feature for this scenario, but you could consider the following workaround:
1. Set the H200 as the paired chime of the doorbell (doorbell Device Settings page > Doorbell > Paired Chime) -- make the hub ring when doorbell is pressed.
2. Change the doorbell's wakeup type to 'event detected' (doorbell Device Settings page > Detection > Wake-up sensitivity).
3. Create automation that uses the hub's ringing status to switch the doorbell privacy mode on and off.
- When H200 Rings
- Then
- Send me a notification
- Disable D230 privacy mode
- Delay 5 minutes <Execute the following action 5 minutes after the above actions start. The time specified here indicates how long you want the doorbell to stay on after disabling privacy mode. However, the actual recording duration is mainly influenced by the activity in front of the doorbell. For instance, if you set it for 5 minutes but no one is present after one minute, the doorbell will automatically enter sleep mode for the remaining time until the delay countdown finishes, at which point privacy mode will be reactivated.>
- Enable D230 privacy mode
☆ How to create Smart Action (Automation or Shortcut) on Tapo app
- Copy Link
- Report Inappropriate Content
Tapo D230 doesn't have a direct feature for this scenario, but you could consider the following workaround:
1. Set the H200 as the paired chime of the doorbell (doorbell Device Settings page > Doorbell > Paired Chime) -- make the hub ring when doorbell is pressed.
2. Change the doorbell's wakeup type to 'event detected' (doorbell Device Settings page > Detection > Wake-up sensitivity).
3. Create automation that uses the hub's ringing status to switch the doorbell privacy mode on and off.
- When H200 Rings
- Then
- Send me a notification
- Disable D230 privacy mode
- Delay 5 minutes <Execute the following action 5 minutes after the above actions start. The time specified here indicates how long you want the doorbell to stay on after disabling privacy mode. However, the actual recording duration is mainly influenced by the activity in front of the doorbell. For instance, if you set it for 5 minutes but no one is present after one minute, the doorbell will automatically enter sleep mode for the remaining time until the delay countdown finishes, at which point privacy mode will be reactivated.>
- Enable D230 privacy mode
☆ How to create Smart Action (Automation or Shortcut) on Tapo app
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 236
Replies: 1
Voters 0
No one has voted for it yet.