Deco M9 acting as Home Hub not showing the correct layout map of Deco
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My home network consists of 7 Deco: 3 Deco M9 (one of them as home hub) and 4 Deco M5. Until now I had Ethernet backhauled part of the network using Ethernet cable, with one connection used a TPLink PLC. So far OK, network working fine and mobile app showing the map correctly.
A few days ago I included a new Ethernet back haul connecting two of my M5 units, and since then the network works fine, but the Deco APP has turned crazy when showing the layout of decos: the 'Show List' works ok, the 'Show Map' misses some of the Deco but not all (I am missing 3 of them), and the layout is changing - not sure but depending on the reset order (my best guess).
@ARGamingPK1 Thank you very much for the notification
.
@aspaviento , sorry, the 1.8.1 is for V2/V2.2 only.
Could you please refer to this link to help me submit the Deco App log here:
It would also be highly appreciated if you could save some screenshots of the "incomplete" network map on the Deco APP, such as:
By the way, how about the actual network layout, such as:
ISP modem----main Deco M9 plus----<cable>---- satellite M9 plus#1----satellite M9 plus#2-----<plc>-----satellite M5#1 ........
Later, I'll check with the engineer to see whether he has any other suggestions.
Wait for your reply.
Best regards.
