Deco X50 – Ethernet Backhaul not detected consistently
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Deco X50 – Ethernet Backhaul not detected consistently
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I recently installed 3 Deco X50 units in different areas of my house.
The main Deco is connected to my ISP’s router, which is set to bridge mode.
All three Decos are connected via Ethernet cables to a central switch.
However, the Deco app shows that the connectivity between the units is wireless.
For a short while, it did show a wired (Ethernet) connection between two of the Decos, but then it switched back to showing wireless.
I’ve tried several removal and reinstallation attempts to get them to reconnect via Ethernet, but this has been unsuccessful.
Is there a way to force the Decos to use Ethernet backhaul?
Thanks in advance
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@ASap Did you try if the suggested "turn OFF switch's loop detection" might fix this?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2273
Replies: 11
Voters 0
No one has voted for it yet.