Be550 new firmware 1.1.3 devices won't connect to wifi
Be550 new firmware 1.1.3 devices won't connect to wifi
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
You say that everything is "back to normal". Does this mean that the 1.1.3 firmware is now free of problems?
- Copy Link
- Report Inappropriate Content
Hi@Maciej,
It means downgrading to 1.1.2 can restore to normal.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Could you please send me new firmware also.....
Be550 vs 1
Australia
Running superloop
1000mbp plan fttp
22 devices
Running cat6 back from the NBN cabinet through a TP-Link 2.5 GB switch at the cabinet so every Device goes through my be550 and not directly to NBN
- Copy Link
- Report Inappropriate Content
Hello@Mtr77 ,
Thanks for contacting our community.
Have you also encountered 'new firmware 1.1.3 devices won't connect to wifi'? Is your BE550 working in wireless router mode or access point mode?
If it's in access point mode, please reset the router and then re-configuring it as an access point.
Downgrading to version 1.1.2 may also restore it.
If it's in wireless router mode, please let me know if your network topology diagram is as follows:
Super loop NBN—BE550—switch
(Note: — stands for wired connection,)))((( stands for wireless connection )
For a wireless connection that is unstable:
1) Make sure the Router is properly placed; it should be put in an open area instead of inside a cabinet or shelf.
2) Change the wireless channel to another one. You may refer to Changing Channel and Channel Width on a TP-Link Router (new logo).
3) Change channel width to avoid interference. For 2.4GHz wireless client devices, adjust the 2.4GHz channel width to 20MHz; for 5 GHz wireless client devices, adjust the 5GHz channel width to 80MHz or 40MHz, etc.
- Copy Link
- Report Inappropriate Content
hi where can i find this new firmware ? just the 1.1.2 not been great for me as had constant wifi connected then disconnected had to go back to my amazon erro
thanks
- Copy Link
- Report Inappropriate Content
@Joseph-TP After updating to 1.1.3, I did a factory reset on the router. Seems to be working now on all frequencies (2G, 5G and 6G). I disabled Smart Connect to make sure that I can connect to all frequencies separately.
Just an FYI.
- Copy Link
- Report Inappropriate Content
@ChuckLox where can I get this firmware ?
- Copy Link
- Report Inappropriate Content
@SmashedAtom My routers are US version. I was able to get them at TPLink US website, Under support. Mind you, TPLink's site normally redirects you to your local site based on your IP addess. I had to use a VPN in my case.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1972
Replies: 41
Voters 0
No one has voted for it yet.