Topology:

• Archer C6 v4 as the controller (FW: 1.14.0 Build 240617 Rel.39521n(4555)).
• Archer AX23 (FW: 1.0.4 Build 20240306 rel.66339) and Archer AX53 v2 (FW: 1.1.0 Build 20230725 Rel. 56344) as nodes.
• All connected via a TP-Link switch using Ethernet backhaul.

Summary:

• When I disable Wi-Fi on the router (Archer C6 v4) and enable it again, the Archer AX23 node resumes broadcasting as expected, but the Archer AX53 remains off.
• There is no SSID or signal, and the Wi-Fi LEDs stay off (see photo).
• Only resetting the AX53 restores Wi-Fi.

Steps to reproduce:

1. Set up EasyMesh with the Archer C6 v4 as the controller and the AX53 and AX23 as the nodes.
2. Turn off Wi-Fi on the C6 v4.
3. Turn Wi-Fi back on.
4. The AX23 resumes Wi-Fi, but the AX53 does not. The LEDs stay off (see attached photo below) and there is no signal.
5. Resetting the AX53 restores the Wi-Fi connection. The issue repeats every time.

Expected:

• The AX53 should restore Wi-Fi in the same way as the AX23.

Actual:

• The AX53 Wi-Fi remains off until it is reset.

These LEDs remain off until the reset:

I disabled, then enabled the WiFi here: