How to downgrade Deco X60 firmware?
Since my deco x60 update to firmware 1.3.0 it detect a lot device that really not exists in my network. also some device connected with Wi-Fi but it detect connect with wire.
I set up my deco network as AP. This's really annoy. If there are possible way to downgrade it?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, thank you very much for the feedback.
Instead of downloading the firmware, it is suggested to update Deco X60-V4.2 to the latest 1.6.0 version:
Deco X60(EU)_V4.20_1.6.0 Build 20250720
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for the feedback.
Instead of downloading the firmware, it is suggested to update Deco X60-V4.2 to the latest 1.6.0 version:
Deco X60(EU)_V4.20_1.6.0 Build 20250720
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP Thank You! This version has fixed my problem.
- Copy Link
- Report Inappropriate Content
@David-TP
Hi David, I have the deco x60 v3.20. Can I install the firmware from the page of 4.20?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP
Do you have the firmware for deco x60 v3.20?
thx
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for your time and patience.
Not yet, I'm afraid it might still take a while for Deco X60-V3.0.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP
Hi again :)
I see here Latest Deco X60 firmware 1.6.0 not available on german Website - Home Network Community
That a deco x60 v3.2 has received the update 1.6.0
Shouldnt be available to download it manually? From your reply here I understand that it's unclear when it's going to be released but some users did get the update?
- Copy Link
- Report Inappropriate Content
Hi, it can be manually updated to the latest 1.6.0. But you might need to download the firmware bin file here:
https://www.tp-link.com/en/support/download/deco-x60/#Firmware
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP
Thank you just updated my units. v3.20
the ability to select 160Mhz Channel width still missing :)
thank you
regards
Georgios
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 533
Replies: 9
Voters 0
No one has voted for it yet.