AX55 firmware release 1.4.1 Build 20250821 rel.70686
OK, This morning my two AX55 (1.3.5 Build 20241211 rel.34816) indicated, that a new firmware is available: 1.4.1 Build 20250821 rel.70686.
I might just update via internet, but normally are more confident with a local file update, but I cannot locate this firmware for download anywhere.
I'm running a pair of AX55 in access point mode (EasyMesh / ethernet backhaul) and does anyone with a similar setup in here have any experience with this new firmware ?
Regrads
zEnterHacker
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @adrianadik ,
Have you tried the beta firmware? Does it help?
If you have any update, please don't hesitate to reply here.
Joseph-TP wrote
Hello @adrianadik ,
You can try the beta firmware here.
Note:
- Please be sure you have read the Beta Test Agreement before upgrading the pre-release firmware!
- For the sake of insurance, it's always recommended to save a copy of the router's Backup Config file before upgrading or downgrading.
- You may follow the guide to upgrade the firmware of your router. How to Upgrade the Firmware on the TP-Link Wi-Fi Routers.
- Copy Link
- Report Inappropriate Content
Hello @StickyToepad81 ,
Have you tried to hard reset the router and configure it again? This might directly eliminate the abnormal VPN connection caused by the change.
- Copy Link
- Report Inappropriate Content
@Joseph-TP I have exactly the same problem. After updating my router today, my vpn client doesn't connect. I checked my vpn file as you said but it only contains my certificate (<ca>, <cert>) and private key (<key>), and there are no lines that contain ##. I tried uploading the vpn file again and doesn't help. Please give me a solution or tell me how to revert to the old firmware. Without the client vpn function the router is useless to me.
- Copy Link
- Report Inappropriate Content
@Joseph-TP This is my current Firmware and hardware Versions after updating and having the client VPN problem:
Firmware Version:
1.4.1 Build 20250821 rel.70686(4555)
Hardware Version:
Archer AX55 v1.0 (EU)
Should I install the original 1.3.5 firmware and downgrade? Or should I install the new beta firmware 1.3.5 which I guess is for US region. Does it work on EU as well?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Joseph-TP Hi, it wasn't necessary fortunately. I've also got Wireguard server to work again by disabling & enabling it, create a new remote account and export the new config file. I've used this link for help setting up the account (Allowed IPs).
I've got a super fast connection and internet speed with it, and resources are accessible (but only over IP-address).
- Copy Link
- Report Inappropriate Content
May I know which special characters are used? Could you provide some of them?
- Copy Link
- Report Inappropriate Content
Hello@StickyToepad81 ,
Just so you know, if your PC is on the same LAN as a NAS, you can easily find it. However, if you are using a remote PC as a VPN client, you may not be able to find the NAS but can still access it by visiting smb://IP of NAS or ftp://IP of NAS in a File Explorer.
More details, please refer to Why can’t I access or discover certain devices over VPN？
- Copy Link
- Report Inappropriate Content
@Joseph-TP There was an @ in my client VPN password which I had to remove it and then it connected.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4950
Replies: 29
Voters 0
No one has voted for it yet.