How can I configure Deco X10 ?
Hello,
There are many problems occuring right now and I don't know what to do because the router keeps failing to deliver internet to it's clients.
Right now there is only the 2 Deco x10 connected to each other by cable. (cable tested by 2 computers with 2.gbps ethernet port)
I can provide the logs if needed, see below some lines of it:
802.11k / band-steering trouble: repeated “Timeout waiting for 802.11k response” for specific clients (e.g., **:**:**:**:**:**), and occasional “Couldn’t get Tx rate” entries for the same client.
Radio/VAP driver errors: frequent rtk_get_vap_status: cfg80211 return -19 (ENODEV) messages, suggesting the virtual AP interface is intermittently unavailable/resetting
DHCP churn: bursts of DISCOVER/OFFER/ACK cycles for the same address (e.g., 192.168.3.***), implying lease instability and contributing to disconnects/reconnects.
ARP flaps: many “client (…) not found in ARP table” right after association events—looks like L2 instability or radio resets.
Steering oddities: “Beacon report for unknown STA 00:00:00:00:00:00” and band mismatch lines during steering callbacks.
How can I fix these problems?
Can I disable wifi 6 and let only wifi 5?
How can I configure my decos like I can in a archer router?
hi @SayeemAhmed
First of all, thanks for your time.
Regarding this, the problem is that this firmware is not for my region, it will void my warrany and I would rather avoid this because I just bought it. Since there is no firmware in my country, better wait a little.
@TP-Link , can your team check if this firmware could be released for all?
@goodevil I am from Bangladesh. It was US hardware. I installed this firmware manually. There was no problem. You can also try it if you want.
