help my tp link mesh stoped wrking so i deletted it and started a new one same internett btw and i have 3 deco i have 2 conected and on wifi working but the 3 one wont restart so i can conect the 3 deco in the app i have tried everything new power cabel reset and so one how do i make the ligthh blue so i can set up the last deco pliz help me its yelow or blinking yelow or red
Hi, welcome to the community.
The factory reset only needs to hold the reset pinhole for 1s.
If it didn't respond to the hardware reset, you can refer to this link to run a firmware recovery:
How to use firmware recovery if the Deco become brick
Best regards.
@michael343 Press the reset button on each Deco unit for 15-20 seconds and then Blue Light will start blinking which mean Deco is fully resetted and in pairing mode and then you can do the setup again in Deco App after delete the old network setup from Deco App.
Hi, welcome to the community.
The factory reset only needs to hold the reset pinhole for 1s.
If it didn't respond to the hardware reset, you can refer to this link to run a firmware recovery:
How to use firmware recovery if the Deco become brick
Best regards.
Helpful: 0
Views: 76
Replies: 2
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
