Home Network Community5G/4G RoutersAuto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
5G/4G Routers

Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
2025-11-17 10:54:35
Model: Archer NX200  
Hardware Version: V2
Firmware Version: 1.1.0 3.0.0 v60e0.0 Build 250812 Rel.76795n

Having issues, switching to 5G but then does not switch back to EWAN, upgraded to the latest version but then downgraded again with no success. Please advise.

  1      
1
#1
Options
4 Reply
Re:Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
2025-11-17 21:04:54 - last edited 2025-11-19 17:56:55

  @Bas2025 

 

Follow this thread for details regarding your issue.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue as a "Recommended Solution". BTC:149wubkkfoLmNDjDbiTxx4ZU8mpcMA5CJt
  0  
0
#2
Options
Re:Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
2025-11-17 21:11:09

 

 

''there is mention of beta firmware , but no download link and if any does it apply to V2?

 

thank you

 

 

 

  0  
0
#3
Options
Re:Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
2025-11-18 16:55:53

  @Bas2025 

 

Hello,

 

Did you read this topic ?

 

https://community.tp-link.com/en/home/forum/topic/825868

 

  1  
1
#4
Options
Re:Auto Failback Issue in NX200 – Not Switching Back to EWAN automatically when fiber is restored
2025-12-02 08:42:29

  @Bas2025 

Hi, thank you very much for your time and patience.

It is suggested to set the PDP type to "IPV4 only" to see whether it helped:

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Wi-Fi Heatmap ready for all Deco models
  0  
0
#5
Options

Information

Helpful: 1

Views: 424

Replies: 4