can't ping router local IP over IPSec tunnel
Hi, I have two identical routers with the same firmware and hardware version. Both are connected via identically configured IPSec tunnels. Communication through the tunnel works fine in both cases i can ping all clients on both sides. The problem is that one router responds to pings to its local IP address, while the second one does not. I've searched through the entire configuration and can't find the setting that controls this.
Hi, thank you very much for the feedback.
Did you set a Site-to-Site IPsec VPN connection between the two Archer MR600s?
Did you also use SIM cards for the same mobile ISP on both routers?
By the way, the default LAN IP on the MR600 is 192.168.1.1. Since there are two identical MR600s, have you tried to change the LAN IPs on both MR600s?
Would there be any chance you could add a network topology to show me on which side the local IP is not responding, such as
Thanks a lot.
Best regards.
Hi@David-TP, both TP-Link routers are connected to a third-party router. The mobile ISPs are different. From 10.10.10.1 I can ping 192.168.3.1 but i can ping 192.168.6.1.
IPSec policy based
