Archer VR900 no LEDs ??
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Archer VR900 no LEDs ??
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hardware Version :
Firmware Version :
ISP :
Hi there.
I've recently acquired an Archer VR900 R1 and there are no LED lights active on the unit at all. Despite holding the LED button on the side of the unit for a variety of seconds, nothing comes on. All else works fine. Does anyone have any idea?
Many thanks
Paul
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
Please check whether you have enabled LED control/night mode.
Login to the web UI of the VR900 first and then go to advanced-system tools-LED control to confirm it.
Meanwhile, ensure the power led is turned on, then you can hard reset by holding the reset button/hole for 10s to give it a shot.
May it help and have a nice day.
pols.robert wrote
Same problem on my VR900.Whats wrong, can anybody help us????
- Copy Link
- Report Inappropriate Content
Thank you for answer . I have not enabled night mode, i did check this first. I will try hard reset later, i hope this will help me.
- Copy Link
- Report Inappropriate Content
Sure, you can give it a go, any further problem, just let us know.
pols.robert wrote
Thank you for answer . I have not enabled night mode, i did check this first. I will try hard reset later, i hope this will help me.
- Copy Link
- Report Inappropriate Content
unfortunately factory reset didn't help me, looks like hardware problem, im not happy, modem is only 5 months old, and led lights stop working... i had some broadband disruption, and i can,t control whats happend, if led lights are not appear...
- Copy Link
- Report Inappropriate Content
If still the same, you can email our tech support with the thread link attached to check the warranty service.
- Copy Link
- Report Inappropriate Content
The problem is not the leds but the plastic cover in front. Because of overheat the white plastic is burned, has become brown and the led light cannot passthrough. None is going to answer your question because this is a quality issue.And I wonder why on a so expensive modem router. I paid 180 euros to buy.
The only way to fix is to remove front cover and drill carefully holes on inside plastic cover trying not to drill the outer. This is difficult because there is glue holding both front plastic covers.
And yes the VR900 OVERHEATS. Since the beggining
- Copy Link
- Report Inappropriate Content
Could you please show us a picture of the actual device?
When and where did you buy this Archer VR900?
And please ensure that you use the original power adapter.
Good day.
- Copy Link
- Report Inappropriate Content
@Paul P Same problem with my VR900 v1 i am using this for almost 3 years and problem happened after the first year.
- Copy Link
- Report Inappropriate Content
What is the led status of the current VR900?
Please provide more information asked in my previous reply regarding to the same issue.
Thanks a lot.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4130
Replies: 13
Voters 0
No one has voted for it yet.