Home Network Community > All Threads > Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
< All Threads

Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-06-01 16:20:06
Model: Archer C6  
Hardware Version: V2
Firmware Version: 1.3.0 Build 20200402 rel.52000(4555)

I just installed my new Archer C6 and the Internet port shows 100mb/s when it should show 1000mb/s. How can i fix that? Have already tried setting up 1000mb/s duplex in the system parameters section.

  2      
 
  2      
 
#1
Options
10 Reply
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-09-18 20:01:03
Same problem for me
  0  
  0  
#2
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-12 05:38:33

I have the same Problem , the internet port speed should show 1000Mbps full duplex link but it shows 100Mbps full Duplex. If i connect a LAN cable to my laptop, the LAN speed shows 1000Mbps which is strange.

 

Please see below screen shot.

 

 

 

Firmware Version :- 1.3.6 Build 20200902 rel.65591(4555)

 

Hardware Version :- Archer C6 v2.0 

 

I am not sure where is the issue 

 

Please help to fix this issue.

 

Thanks,

 

Rama

  0  
  0  
#3
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-12 06:00:22 - last edited 2020-11-12 06:03:08

@Ramachandran 

 

IMHO this is a FW glitch:

 

On LAN2 the device has been shutdown.

 

On LAN2 the device has been turned on.

 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#4
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-13 08:03:36

@Ramachandran 

 

Hello, thank you for asking, can I have the model of your modem, which is connected to the C6 WAN/Internet port? What if you plug the modem directly to a PC with the same cable, will it link at 1000Mbps?

BTW, how long is the cable between the C6 and the modem? Try a shorter cat5e or cat6 cable, thanks.

 

@Ivaylo Hi, do you mean when the device connected to the LAN port if powered off, it then shows 100Mbps on the router web GUI? What kind of devices connected to the LAN2? Does it behave like this no matter what kind of devices connected? Thanks.

 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#5
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-13 20:53:52 - last edited 2020-11-15 03:13:08

@Kevin_Z

 

Yes, that's what I've meant. It's actually 10 Mbit/s when the PC ( http://global.shuttle.com/products/productsSpec?productId=1628 ) is off. When turned on, it shows 1000 Mbit/s as it should be. Will try to connect my laptop by cable to see if that persists.

On another occasion (I observed this once only) at LAN1 it showed 100 Mbit/s while it should be 1000 Mbit/s. Simple unplug/plug of the LAN cable (15 meters) fixed that.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#6
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-16 02:01:20

@Ivaylo 

 

Thank you very much for this valued info. Please kindly help confirm if this always shows 10 Mbit/s when another PC or laptop is connected to the LAN port.

 

BTW, are you using cat5e or cat6 cable between the C6 and the PC?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#7
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-16 18:39:15 - last edited 2020-11-17 03:03:54

@Kevin_Z 

 

OK, tested with different ethernet cables (CAT5e/6) few times - it persists.

When I've connected my laptop (by cable to the same LAN2 port), then it was OK. When laptop is shutdown the status is disconnected.

I believe it's more related to the device type (connected to the LAN port) than the cable itself.

For example:

On the other LAN ports: LAN3 and LAN4 I have a Smart TV and another PC connected.

The issue there is just that when they are off/shutdown the status says "connected" at speed 100 Mbps(speed is correct).

I am not sure if that can be related, but I have WoL enabled on both PCs (LAN2, LAN3 ports).

To summarize C6 related issues you can take a look and add to the list this and this thread which stay unattended.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#8
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2020-11-19 09:58:32

@Ivaylo 

 

Thank you very much for your testing, we will check the other thread and try to find some clue, good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#9
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2021-04-23 16:48:25

I've exact same problem using AC5400, v2 with latest firmware. I'm using Unifi 300Mbps package. there is no problem using Unifi supplied Dlink router, but with TPlink, it can only connect with 100Mbps

 

when change the system parameter to 1000mbps, full duplex, then TPlink show internet cable not connected, even after trying multiple Cat 6 wire, still same

 

some help would be helpful, else I'll have to sell TP-link and buy other brand

  1  
  1  
#10
Options
Re:Archer C6 Internet Port negotiation speed at 100Mpbs,when it should be 1000Mbps
2021-04-28 06:34:49

@CK.K 

 

How many LAN ports on the ISP provided modem? You can check if there is any difference with those ports. We do receive some feedback that there are different types of LAN ports on the modem, some are 100Mbps, and some are 1000Mbps. BTW, what is the model number of the modem?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#11
Options

Information

Helpful: 2

Views: 5192

Replies: 10

Related Articles
Internet Port Negotiation Speed issue with Archer C6 - unable to get negotiation speed of 1000Mbps
5932 5
Archer C6 - Ethernet negotiation at 100Mbps
24408 0
Archer C6 v2 negotiation speed issue
1243 0
Archer C2 - Internet Port negotiation decreases
1013 0
Internet Negotiation speed at 100 Mbps in gigabit port.
655 0
Archer C6 Internet Negotiation stuck at 100 mbps
523 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.