TP-Link Archer VR300
TP-Link Archer VR300(EU) Ver:1.2 S/N:2212133002554
Hello , I have a problem with router after reset. Only Power LED blinking, anything else not working. 192.168.1.1 not working. I also tried reset it again but it won't help.
Any sugesstions?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for your feedback.
And if anyone had the same issue, it is highly appreciated that you could help me check the following information:
1. How long have you had the modem and when did this issue start?
2. Please help me record a video clip of the LED lights after power-on. For example, the power light is on for 10 seconds and then keeps blinking.
3. What causes the problem to happen, such as a factory setting? Or it happened after upgrading the VR300 firmware? Or did the problem suddenly happen without doing anything?
4. Are there any sudden power failures or lightning strikes?
5. When resetting the device to factory settings(by holding the reset pinhole for 10s), will the device respond?
Thanks again for your cooperation.
- Copy Link
- Report Inappropriate Content
1. I bought modem 2 months ago.
2. Yes, the power light is on for 10 seconds and then keeps blinking. I will sent you video.
3. In my case it happend after factory reset.
4. No
5. Reset doesnt help.
- Copy Link
- Report Inappropriate Content
1. I bought the modem about 3 Weeks ago.
2. Yes, the power light is on for 10 seconds and then keeps blinking (Video attached).
3. In my case it happened after factory reset.
4. No
5. When resetting the device to factory settings(by holding the reset pinhole for 10s), all the leds turn on for just one second and the device restart but nothing new after that the power led still blinking (Reset doesn't help).
- Copy Link
- Report Inappropriate Content
Hi, Thank you very much for the detailed information.
After confirming with the senior engineers, a full reboot of Archer VR300 would take about 35-40s.
So Were you use to reset after the power light blinked for 35-40s?
After that, please try to contact the local support team to ask for the warranty service.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 5
Views: 1785
Replies: 5