How to connect red blinking X20 node to a network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to connect red blinking X20 node to a network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to connect red blinking X20 node to a network
How to connect red blinking X20 node to a network
2021-11-16 03:54:53
Model: Deco X20  
Hardware Version:
Firmware Version:

I just added X20 in a network with E4 as the primary. Later on I made the X20 as the master and remove all the E4 nodes. I was successful in doing this but unfortunately I accidentally remove the network as it still shows the E4 network.  How do I reset the x20 nodes so that I can add them to the new network?

  0      
  0      
#1
Options
1 Reply
Re:How to connect red blinking X20 node to a network
2021-11-17 03:26:53

@Boyet 

Hi, I see that the Deco X20 kit is online again.

And I guess you have fixed your issue already?

 

If not, there are some suggestions:

1. Delete all the invalid old network names first on the APP.

2. Reset the main X20 by holding the bottom reset pinhole for 1s and follow the setup instructions on the APP.

3. Reset the rest of the other satellite X20s if their LED could not be blinking blue.

4. Since Deco X20 had a pre-configured program, normally we just need to wait for about 1mins, all the satellite X20s would be added to the APP automatically.

Thank you very much.

 

 

  0  
  0  
#2
Options