How do I turn off AP Isolation?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have two issues and I think they are related.
First I can not add either Satellite 2 or Satellite 3 to my Deco M9 plus network. It is not finding them.
I have since connected a couple of tablets and phones and a laptop to the network as it sits right now without any satellite Deco units and they are working and connecting to the Internet.
Since I was able to connect the tablets and laptop I decided to connect up a couple of my Google Home devices. In both cases, they connect to the network and I can see them in the listed devices connected to the network, but I get the following error on my phone when trying to finish up the install.
Your Nest Hub Max was setup successfully but can't be found. Make sure your mobile device and Nest Hub Max are on the same Wi-Fi network.
Turn off AP isolation
If AP isolation is enabled on your Wi-Fi router, you will need to disable it.
Since I am not finding the Deco Satellite units or finding my Google devices I am thinking it is an AP isolation issue. So I did a search on the Internet for a solution on how to turn off AP Isolation on the Deco M9 plus but I could not find an answer to that.
My previous Wi-Fi router was the TP-Link C5400 and everything was working fine. I am upgrading to a meshed network as the number of devices in the house is climbing and I thought the Deco M9 plus would be the answer to solving some of the issues I am having. So far it has only created more problems than it has solved.
My Deco M9 plus connects via Ethernet to my Motorola SB6141 Cable modem.
