@Kevin_Z the issue looks similar. But, since I have no DNS server in my network it's ok, that the dns ip is the same as the gateway ip.

The entries in default gateway and primary dns are consistent with the new ip address.

For me the new ip address is the problem.

I have clients with static configuration, which cannot reconnect to the internet after the ip of the default gateway (tp link router) is changed.

Also their name resolution is broken.

The client from which I do the configuration (static ip client) also could not find the gateway and the webinterface anymore.

For the dhcp clients the problems came, after I changed the ip for the local network back to the correct value, as their dhcp leases had to be renewed which takes some time (or a reboot).

In general I think it's a bad idea to change the lan ip of a device that quite likely is used as a router during a update, or without explicit notification of the admin.

 Hello @Kevin_Z 

I installed the beta firmware. It fixes the issue of the changed internal IP address. After reboot the system had the same local IP as before.

Thank you very much.

Florian

  @Kevin_Z 

Estou com problema na configuração do Qos do modelo Tp link acher c80.

Ele não respeita a largura de banda que eu estabeleço.

No caso 80 dow, 80 up.

Se eu colocar um dispositivo como prioridade e fizer um simples medidor de conexão, a velocidade de download ultrapassa muito. Chega a mais de 350 mb. Upload também.

E não é esse o objetivo do Qos, era justamente pra limitar a banda e priorizar o dispositivo setado cono prioridade na hora de um tráfego maior.

  @Lamartine 

QOS guarantees a minimum speed. It's not used to limit speed.

If you want to limit the bandwidth of a device you should go to:

Network Map -> Clients

edit the client that you want to limit

"enable speed limit"

if you have QOS or NAT boost you will get a message that this will be disabled

Then you get a window where you can set upload and download speed limits.

regards,

florian

  @florian666 

Na realidade adquiri esse roteador para resolver o problema de bufferbload na minha rede. E ao usar o Qos dele não consigo com que isso aconteça.

Para jogos online continua com muito bufferbload.

Aqui a conexão é Fibra óptica. 500 Dowload e 250 upload. 

E o ps4 está conectado vis cabo de rede ao roteador