Deco X20 1.1.0 Build 20230725 - Missing Clients connection preference

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X20 1.1.0 Build 20230725 - Missing Clients connection preference

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco X20 1.1.0 Build 20230725 - Missing Clients connection preference
Deco X20 1.1.0 Build 20230725 - Missing Clients connection preference
2023-08-22 11:05:58
Model: Deco X20  
Hardware Version: V3
Firmware Version: 1.1.0 Build 20230725 Rel. 55457

Hello,

recently i receive the update for my 3 Deco X20. They upgraded to 1.1.0 Build 20230725 Rel. 55457, which from the changelog should add new features too like customizing Clients connection preference and Satellite signal preference

 

My Decos are in a meshed network with 3 Deco X20 and 2 Deco M4R

 

As of now i can see the settings for customizing the Satellite signal source on my X20, as is visible from the picture below. But i am missing the Client connection preference. I only saw it briefly after the update, then i made a reboot of all the 5 Decos to start clean after an update and see if everything was ok. Since then, if i go inside any X20 satellite page and select a client, i don't find the "Connection Preference" option. There are only the legacy preferences like "Priority" or "Disable mesh"

 

Have any info? I added some pics below for clarity

 

Thanks

 

Satellite source signal is present

 

Missing client connection preference

  1      
  1      
#1
Options
1 Reply
Re:Deco X20 1.1.0 Build 20230725 - Missing Clients connection preference
2023-08-23 08:32:14

  @x3y0s 

Hi, thank you very much for the feedback.

the issue is due to the mixed Mesh system. For satellite Deco connection preference, it is customized and visible on the Deco APP as long as the selected Deco supports this feature. But for the Clients connection preference, it needs the support from all Deco units in the Mesh which for your case, the current firmware of Deco M4 v2 does not support this feature yet.

Thanks a lot and best regards.

  0  
  0  
#2
Options