Home Network Community > All Threads > I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.
< All Threads

I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.
I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.
2023-08-27 11:37:02
Tags: #Default Gateway IP address range
Model: Deco E4  
Hardware Version:
Firmware Version: 1.5.4

I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range, but the Default Gateway is Greyed Out.

 

  0      
 
  0      
 
#1
Options
3 Reply
Re:I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.
2023-08-28 02:41:30

  @COiSman 

Hi, You might need to change the LAN IP under Deco APP>More>Advanced to 10.0.0.1 first.

Thank you very much and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.
2023-09-15 17:14:43

  @David-TP Thanks for your reply. I tried that but then get the following message: Maybe you can direct me in solving this?

 

  0  
  0  
#3
Options
Re:I want to change the Default Gateway IP address range from 19.168.68.1 to the 10.0.0.1 IP range.
2023-09-15 19:13:43 - last edited 2023-09-15 19:14:16

  @COiSman 

 

You must have ISP router that you configured with 10.0.0.* IP range. You connected Main Deco to it. You want devices that connect to Deco mesh to be in the same 10.0.0.* IP range.

If this is your current setup, the way to achieve what you want is to configure Deco mesh to run in Access Point mode: Switching a Deco to Access Point (AP) Mode

  1  
  1  
#4
Options

Information

Helpful: 0

Views: 1560

Replies: 3

Tags

Default Gateway IP address range
Related Articles
Not default gateway IP Address
1243 0
Change IP Address
914 0
Can't change LAN IP address
5690 0
m7200 change static ip address
1223 0
Default Gateway unplugged
2941 0
Change IP address
1201 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.