Hello,

I want to ask if is normal that after upgrade I getting constant red light fod few seconds during boot of Deco X50? If I need to downgrade fw.

I have two packs of X50s. One with FW 1.2.2 and one had 1.3 and accidentally upgraded to 1.5.5.

When I reboot 1.5.5s light sequence on main unit goes yellow-red(2s)-green. Sometimes yellow-blue(0.5s)-red(1.5s)-green. It is normal? Because 1.2.2s main unit boot is just yellow-green.

(I am just worry because I had Deco M5s and they died for constant red light.)

Colors are same for Router and AP modes. For both have Dynamic IP from main routerboard.

So I want to rather know if downgrade to 1.2.2 will vanish that red light. Because I want use deco for my wifi and not worry about dying for red light as happened on Deco M5 what I had. Thank you.

Btw I already returned that 1.5.5s X50s. So I have at home only X50s with 1.2.2 FW and works fine, with yellow-green boot sequence but want to know IF it SAFE to upgrade. Because of red light in boot sequence on 1.5.5 FW. Thank you.