@Paul_B1 there are times when the connectors don't match up or a crimp on end warps the plastic a little and one of the pins does not make good contact. because power and communications does not use...

802.3af and all active Poe is a negiotiated power source. Passive just applies voltage to the line. This can for sure cause problems when the amperage is to high at 48v. I will attach the readings...

@nbali Im sorry , my work around was to go back to my Cisco RV320 . Im waiting for a solution from TP-Link. so for now my TP-link router is sitting colletcing dust. the worst part is have sold a half...

deny all protocols, source: network interface for VLAN 30 to destination: other network interfaces/VLANS" - This is at the bottom of the ACL stack. With only this enabled I can't ping/connect to HA...

@trimmkm By default traffic will flow between vlans. Can you isolate what might be different between the connections that work and those that don't? Wireless / wired? What are you networks per VLAN?...

@Fae Thank you for the information. I look forward to future releases. Is there an option to apply to Beta test firmware releases. I work in the networking industry and would enjoy providing feedback.