@Franz_F-17 Hi, I see. You may want to use link backup feature, check this: How to configure Link Backup on Dual WAN Router

@seawolf88 Are you sure the management page you logged is the same CPE? Maybe you have multiple CPEs with the same IP address, and you logged into the wrong page?

@Dectro I'm not sure what config file you wanna find, but you can see the opvn. file on the controller if you are talking about the openvpn.

@-RB- Hi, have you tried disabling the Band steering feature? Actually, how many 2.4G clients are in your network in total? Are these clients a little far from the APs? Have you tried to move them...

@RADEB You can set the ACL based on the IP address, but you need to bind the IP address to the wired devices' Mac address like IP-Mac binding.

@heimdall You need to make sure the allowed IP address you set on the router Wireguard VPN Peers page is the same as the IP address shown on the Wireguard Client Interface page. Look at this document...