@Vincent-TP Yes, all show up as wired on the switch port the EAP is connected to, switch model is currently SG3210 v3.2 FW 3.20.13 Troubleshooting - yes -reboots, resets, reprovisions, making sure...

@Vincent-TP EAP683 UR 1.4.50 beta firmware does not interact properly with controller v6 beta - all clients show up as Wired and attached to the switch, not the EAP Reverting it to 1.3.0 Official all...

@Ethan-TP I had to do a SSH roll-back and then a re-upgrade in the end. On 1.3.3 beta the gateway would not accept any firmware file other then the beta posted here

@Ethan-TP I cannot upgrade from this beta to the official 1.3.3 from the support site which is a later build From the 1.3.3 official changelog Important Notice: It is recommended to upgrade to...

@Tescophil Unfortunately it is just as spiky as 2.3.0 and the two betas since No traffic on this site, i know the house was empty and it was basically idle which you can see when the clients drop to...

@Babun-Sikder Cant you achieve exactly this by - remove the overall SSID rate limit - Add a gateway bandwidth control per vlan used in the PPSK ??