@TPOllihome Usually means it trying to mesh... I would double check the cabling. Make sure everything is seated tightly. you could have POWER over 2 POE pairs, but shaky data over the cable.

@KrypticPhish I did notice my connectors had to be seating into the back of the in wall fairly hard. Could be my connectors, but Just something I noticed. I would get anything Fluke for cable...

@dfalessi Goto the Knowledge base and look up how to change the main/core subnet. That will solve your issue.

@Coenie Have you tried to disable mini data rate?

@KrypticPhish I would get a cable tester to confirm the cable does pass the test? Also have you tried a different switch port? I have the 615 all in the wild and they run fine and duplex at 1G....

@Eric-jones12 Regardless of the PBR setting the Failover should work if enabled. Thats in the Internet/WAN section of the controller.