@Virgo If I disable all the rules it seems to work, but I can't get it to a state where I can access the IoT network from the main LAN, but not the other way around. It seems like the way it worked...

I have an IoT wifi network set up with ID 123, and have added a LAN with that ID as well. Then I had a gateway ACL set up to block that VLAN to access the internet, and a EAP ACL to block the VLAN...

Thanks! I'm just a bit concerned because I did see there is 1.0.1 and when I check it just gives "general error" rather than telling me there are no updates. But 1.0.1 has the same controller version...

@aschmid I got the following reply from support, so it looks like not a fundamental issue, but with that said, never buy a promise. Unfortunately, current firmware does not allow to set PVID on ports...

I read that in Omada Controller 5.6 support for an mDNS service will be added. However, my router is on 5.4.20 and I can't seem to find a way to update it? When I go to the controller settings I do...

I was indeed kind of expecting this to be possible. How else am I going to put a wired device in a specific VLAN?