NeilR_MOnline
Following: 0Followers: 0
Forums/ Controllers
15 hours ago
Re:Isolating one network device
@Seensent Sounds like ACLs should meet your needs. Assign a static IP to each of those devices, then set up ACL rules for that specific IP to only communicate with the internet, and deny traffic to...
0HELPFULS
Forums/ Controllers
15 hours ago
Mini yet Mighty: OC220 Hardware Controller Out Now!
OC220: Omada Hardware Controller Now Available! Introducing the all-new OC220, a mini yet mighty controller that allows you to manage your network without the need for an additional PC or Server....
0HELPFULS
Forums/ Gateways
20 hours ago
Re:Blocklist in ER707-M2
@rifodk Yes, you should be able to achieve this with ACL rules. Create an IP Group with those specific IPs, and then create an ACL rule that blocks all incoming traffic on your WAN from those IPs.
0HELPFULS
Forums/ Wireless
22 hours ago
Re:eaps 225 are not getting gbps speed
@Dipak-OMF How are you testing the speed? Can you show the speedtest you're getting from your device? Also, can you ensure the firmware is fully updated on all APs and on your OC200?
0HELPFULS
Forums/ Gateways
23 hours ago
Re:Block VLAN to configuration
@damianstelmach You'll want to review the ACL rules (in Standalone, these can be found under Firewall -> Access Control) and block HTTP access from the specified IP groups.
0HELPFULS
Forums/ Wireless
Yesterday
Re:Running a PoE camera from the secondary ethernet port of a TP-Link Omada EAP245 v 3
@resolution Hey, thanks for your post! Unfortunately, POE passthrough is not supported on this device.
0HELPFULS
12