@PavelV Sure I can confirm this too, along with a ton of other bugs that I can not even bear to mention. The updates are only getting worse and worse, I have probably never experienced so many bad...

@bincomIT I have experienced the same thing, do you have switch ACL on your installations? I have found that if I disable the switch ACL then there are less problems.

@4uba If you have access point in a remote site then you ned to open /nat in 29814 in to controller in addition to the old port TCP 29811-29813 + UDP 29810 so new port is TCP 29811-29814 and UDP...

@Alex_UTS then I have no suggestion, I fixed the problem by opening the new TCP port 29814 in the firewall. What firmware do you use on the access points?

@Alex_UTS I guess controller is remote, Tp-link have change adoption port to 29814 TCP and remote device not adopt without this port opened in firewall

@doremifajb This is quite simple, you need to install Omada first with the instructions above, then you need to change the HTTP Portal port to 8844 in omada so, stop and start omada controller with...