Forums/
Routers
15 hours ago
@Clive_A I don't think there is a routing problem on the wireguard server that runs on linux, then it wouldn't help to set 0.0.0.0/0 on the TP-Link router. moreover, the wireguard server works for...
0HELPFULS
Forums/
Routers
20 hours ago
@Clive_A Clive_A wrote Hi @MR.S Thanks for posting in our business forum. MR.S wrote @Clive_A Do you have any tips? I have connetction to the wireguard server but I don't get any traffic in the...
0HELPFULS
Forums/
Routers
Yesterday
@Clive_A Do you have any tips? I have connetction to the wireguard server but I don't get any traffic in the tunnel until I enter 0.0.0.0/0 but I don't want to route all traffic through the tunnel...
0HELPFULS
Forums/
Routers
Monday
@Clive_A I finally succeeded in connecting a TP-Link router to a wireguard server. but it is not easy. as I mentioned earlier, this would have been easier if I could change the Server Public Key on...
0HELPFULS
Forums/
WiFi
Sunday
@Hans1234 I had the same problem, but I got an updated firmware from support. no problems after upgrading to 1.0.90 Build 20231012 Rel. 31553 @Hank21 can you make this version available on the forum?
0HELPFULS
Forums/
Routers
Sunday
@a-sam yes I experience the same, with VPN configured it is even slower. I got a UXG-Lite a few days ago, unifi's weakest router, but it actually manages close to 1GB with IDS/IPS enabled. This is a...
0HELPFULS