@svrijssel Hi, Did you update the firmware via WiFi or Ethernet cable? Does it help if you only update the firmware on one of the satellites Deco X20_V3 via IP address first? The IP address of the...

@oneframe Hi, Do you plan to switch the channel width from 80 MHz to 160 MHz? -Can I have a screenshot that "my channel selection is grayed out"? Does it help if we temporarily remove the satellite...

@MaleHumanUK Hi, based on the previous feedback, the combined backhaul sometimes caused a network loop on certain occasions. So 1.1.2 version here has temporarily disabled the WiFi Backhaul when the...

@Jannek999 Hi, yes, the beta firmware in this post is to help us downgrade from 1.8.0 to the official 1.6.4. Best regards.

@Agelwahidy Hi, Thank you very much for the time and patience. Deco X20_V3 is also planned to support Matter but the ETA of the relevant firmware is still not clear yet. Best regards.

@jamie_r Hi, can I have the current firmware version for Deco X20? If there are two satellites Deco X20, it is suggested to swap their locations to see whether the disconnection follows the specific...